Occupancy Sensors
Standard

Can also be used with the klik range of products.

Automatic lighting control which can provide energy savings by not operating when sufficient natural light levels exist.

Automatic lighting control providing energy savings by not operating when sufficient natural light is available.

High sensitivity detection will react to small movements, such as somebody working at a desk.

Motion detection will react to larger movements, such as walking or waving arms.

Potentiometers allow control of time overrun and photocell set point.

Hidden behind a discreet sliding cover the potentiometers allow limited control of sensors.

Lux setting can be increased and decreased in increments of 100.

Allows set point to be increased or decreased in 100 lux steps from the EEK001 remote programmer.
Makes adjustment of photocell set point convenient.

Time out adjustment:

2 min - 57 min with remote programmer
1 min - 1 hour with potentiometer

Wide operating range to suit most commercial applications.

Allows overrun of lighting to be customised to installation.

230 VAC power supply 2.4VA / 270mW.

Standard supply for commercial applications.

Incandescent Halogen - 2300W
Halogen ELV via ferromagnetic or electronic transformer - 1500W
Compact Fluorescent - 23 x 23W
Parallel compensated fluorescent tubes - 1000W
Fluorescent via electronic ballast - 1000W

Up to 24 DSI or DALI ballasts.

3m 1.5mm² Low Smoke Zero Halogen for Relay model.

3m 0.75mm² Low Smoke Zero Halogen for Digital model.

Reduces installation time on site and requirement for non standard cable.

Allows lighting to be controlled ensuring that lighting is only energised when people are in the detection area.

Requires lighting to be activated by a wall switch or remote control to switch lighting on. Lighting then remains on
during presence and switches off after time out period from last presence detection. Offers potentially the best
energy savings.

Allows lighting state to be changed between states or dimmed up and down on digital fittings.

Provides an aid during commissioning.

Can be flush mounted through a 60mm hole, utilises spring clips to ensure a fast and secure mounting method.

Suitable for different ceiling types including tile and plasterboard. Only requires 70mm ceiling void.

EEK001 programming tools allows full utilisation of sensor features.

Programming tool is easy to use with 2 memory settings to enable repeatability.

EEK002 remote control allows manual override of lighting output. On dimming, installations will raise or lower light levels and has 4 adjustable scene sets.

Comes with a wall mounting bracket for storage and allows room occupant to have control of lighting output.

LED on sensor confirms when instruction is received from EEK001, EEK002.

Visual confirmation of programming change.